When you own a house, maintaining a driveway can really be a herculean task to do. The continuous use of driveways leads to depletion and corrosion of the top layer that ultimately wears them off. As it can be such a strenuous task to repair a driveway and the fact not every household has the right tools, a lot of homeowners opt to use asphalt contractors st marys county to repair or even replace a damaged driveway. Sometimes, it’s much easier using a professional service so that you can let the professionals get on with the job and end up with a good quality driveway. However, if you want to repair your driveway yourself, you can with a little help.
Repair of your asphalt or concrete driveway might cost you a lot that can have a significant impact on your monthly budget. Thus, to avoid this source of the financial crisis, we have jotted down below some simple steps that might assist you in repairing the driveway all by yourself.
-
Get rid of dirt and dust
Now, start your repair world by first dusting off the dirt and dust from the surface in order to have considerably smooth reconstructing procedures. Use a stiff bristled broom to get rid of dust particles and then use water to make the area completely clean. Before proceeding with the repairs, make sure that the area is completely dry.
However, remember if you decide to use water, it will seep into the deep cracks of driveways and when you cover it, the moisture will get trapped that can cause problems down the road. Make use of the bush blower for any stubborn dust or dirt.
-
Remove the vegetation
Driveways with more extensive cracks usually grow vegetations and it a must to get rid of them before you start with your repairs. Consequently, make use of sharp-angled gardening tools that are very readily available. Stick the angled part in the ground and pull it towards you to haul out the weeds and vegetation.
The market is loaded with numerous tools that might assist you in tugging out the vegetation. A special tool is available that spits out a scorching flame that roasts the entire vegetation within a few seconds. So, you can use any method to prepare the driveway for repair treatment.
-
Repair the potholes
If your driveways are loaded with potholes, then all you need is a pothole patch and a tamper. So, check whether the pothole goes past the bottom of the asphalt or concrete layer. If the hole is deeper, then you first need to fill it up with sand, gravel, and dirt. You can also make use of pothole patch, but it will be a complete waste of material if you’re quite tight on your budget.
Don’t forget to calculate how much gravel you might require in order to fill your potholes completely to avoid the waste of material. Once your pothole is filled, make it even by pounding on the pothole tamper to flatten it out.
-
Repair the cracks
After the repair of your potholes, you need to get rid of the cracks that make your driveway look crooked and unmanageable. All that you need is the patch material, seal coat sealer and a squeegee to do away with all the cracks.
Now fill in the cracks by using the patch material and then, allow it to dry. Now, use the squeegee to make the crack repair stronger. Use the seal coat in the end to bond all the material used to repair the crack. If you’re not a fan of the damaged driveway look (even though you’ve repaired it) as the cracks can be somewhat unattractive on a well-laid driveway, then you might instead want to look at having your driveway resurfaced by a professional, such as a company like alpine asphalt or another. This way your driveway will be crack-free. It should once again look inviting and appealing, further increasing the curb appeal of your property.
